![]() To confine the tablet stylus to one monitor you'll need to use xinput's CTM (coordinate transform matrix) property. You'll find some application specific comments on the DIGImend site. Would need some more information I suppose. Not sure what the cursor offset while in "window mode" is about. See the Graphics tablet on multi-monitors HOW TO. The code does the actual matrix multiplication. Then using that information you calcuate a few fractions to get the scaling values for the xinput CTM command you'll apply. You just use the pixel dimensions of both monitors and where they are located relative to one another. The evdev driver supports it and it's fairly easy. Other useful information and HOW TOs for UC-Logics are here. ![]() ort_status Which means the kernel driver for it works and so it is picked up by the evdev driver which is now the designated X driver for it rather than WizardPen. Your UC-Logic WP8060U (5543:0064) is supported according to the DIGI mend project. ![]() Inkscape, GIMP, MyPaint, and Synfig Studio seem to see it as a "tablet" though running it in "window mode" "works" but the cursor is offset dramatically.Īny and all help is appreciated. Aiptek HyperPen 10000U****īus 005 Device 002: ID 0461:4d0f Primax Electronics, LtdĪlso to note, there are no settings for the tablet in XORG conf as that is set by the ATI Catalyst driver and its accompanying "Control Center" software. Mass Storage Device (Multicard Reader)īus 004 Device 002: ID 04d9:1818 Holtek Semiconductor, Inc.īus 001 Device 006: ID 045e:063e Microsoft Corp. Code: Select all Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hubīus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hubīus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 001 Device 003: ID 13fd:1040 Initio Corporationīus 002 Device 003: ID 0bda:0151 Realtek Semiconductor Corp. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |